Settings
The plugin’s settings
Open these with Plugins → Z-Wave Controller Backup → Configure. Most people can leave them all as they are.
| Setting | What it does |
|---|---|
| Backup folder | Where backups are saved. Leave it blank to use Z-Wave Controller Backups in /Library/Application Support/Perceptive Automation/, beside the Indigo folder. To use another folder, type or paste its full path, starting with / or ~. Quotes around a pasted path are removed for you. The folder is created if it does not exist, and a path that does not start with / or ~ is refused. |
| Serial port | The port the stick is on. Leave it blank and the plugin uses the one Indigo’s Z-Wave interface uses, which is right for almost everyone. Only fill it in if the plugin says it cannot find the port in Indigo’s settings. |
| Wait for Z-Wave to be switched off (minutes) | How long a backup, verify or restore waits for you to switch Z-Wave off before it gives up, 10 minutes to start with. Any whole number from 1 to 60. |
| Debug logging | Adds extra lines to the Event Log, including progress through each read and write. Only useful when chasing a problem. |
The plugin needs no password, account or key, so there is nothing to put in IndigoSecrets.py for it.
The device’s settings
The Z-Wave Controller device has no settings. The Your device page explains what it shows.